Track Light Size Track Light Installation Notes

The orbital track contains a voltage input inside the track, on both sides inside the track contains a conductive metal strip, and the track lamp joints have rotatable conductive copper sheet, when installed, the conductive copper sheet above the track lamp touches the inside of the track The conductive metal strips can be energized by the track lights to illuminate the track lights. Next, Xiao Bian introduced the track light size and track light installation precautions for everyone.

Track light size

1, 3W mounted track lights

The lamp head diameter is generally 5.2cm, the height is generally 16cm, the lamp length is 10cm, and the mounting box is approximately 10.3cm long.

2, 7W mounted track lights

The lamp head diameter is generally 7.1cm, the height is generally 17cm, the lamp length is 11cm, and the mounting box is approximately 9.7cm long.

3, 12W mounted track lights

Lampholder diameter is generally 9.9cm, height is generally 26cm, lamp length is 18cm, installation box is about 9.7cm long.

4, 18W mounted track lights

The lamp head diameter is generally 11.4cm, height is generally 27cm, lamp length is 17.7cm, and the mounting box is approximately 9.7cm long.

Track light installation considerations

During the installation of the track light, it is necessary to avoid touching the surface of the lamp by hand. There is also a place where corrosive gas is installed at the heat source. If these are installed, the service life of the track lamp will be affected. When there is an installation, the place must be shaken and shaken without trial, and of course there are hidden dangers to determine that there is no fire.

When using track lights, we try not to switch as often as possible. Because the current flowing through the filament is higher than the current during normal operation at the moment of frequent start-up, the temperature of the filament rises rapidly to accelerate sublimation, which reduces its service life. So we need to reduce the track light fixture del switch lamp in daily time.

Track lamp maintenance method

When using track light lighting, try not to switch as often as possible. Because the current of the filament is higher than the current during normal operation at the instant of frequent start of the lamp, the temperature of the filament will increase rapidly to accelerate sublimation, which will greatly reduce the service life. To minimize the switch of track light fixtures. In the cleaning and maintenance, care should be taken not to change the structure of the lamp, nor to replace any parts of the track light lamp. After the cleaning and maintenance is over, the lamp should be installed as it is. Do not miss or replace the parts of the lamp. The provided light source parameters replace the aging lamp in time. When the lamp is found to be red at both ends, the lamp is black or dark, and the lamp does not light up, the lamp of the track lamp should be replaced in time to prevent the ballast from burning. Bad and unsafe phenomena.

Editor's summary: About the track light size and track light installation precautions are introduced here, I hope to be helpful to everyone. If you want to know more about yourself, you can follow the information on this site.

House Decoration Precautions Construction Installation Home Decoration Size Data Home Decoration Precautions Decoration Remarks Track Light Size